SCREEN Replacement of LCD Cracking in ASUS UX31E Repair Method, Decomposition Procedure
If the screen of ASUS UX31E has a cracked LCD and there is a bad display on the LCD, a liquid crystal panel replacement (LCD replacement) is required!
[ASUS ZENBOOK UX31E LCD Repair and Decomposition Method STEP 1]
I want to repair the liquid crystal crack of ASUS UX31E.
Unlike standard laptops, LCD panels are very thin and delicate.
If you do the wrong method, it will lead to other failures, so please work carefully.
[ASUS ZENBOOK UX31E LCD Repair and Decomposition Method STEP 2]
First of all, the battery is removed from the personal computer itself by turning over the laptop body.
The battery of the UX31E is a built-in type and cannot be removed immediately, but if you proceed with the decomposition as it is, there is a risk of shortcircuit, so you will work after removing the battery.
When the main body is turned over, there are screws, so remove all screws on the back.
[ASUS ZENBOOK UX31E LCD Repair and Decomposition Method STEP 3]
Because it cannot be removed by the Phillips screwdriver, prepare a Torx screwdriver.
(Torx drivers can be purchased at home centers, etc.))
If all screws can be removed, the bottom case can be removed.
[ASUS ZENBOOK UX31E LCD Repair and Decomposition Method STEP 4]
There is a connector connecting the motherboard and the battery in the red frame, so remove it.
It is recommended because the work efficiency is better if you close the bottom case once after removing the connector.
[ASUS ZENBOOK UX31E LCD Repair and Decomposition Method STEP 5]
The LCD frame of the UX31E does not have a single screw.
Because it is fixed with a strong double-sided tape, it peels off slowly.
If you have a hair dryer or a heat gun, you can remove it smoothly by lightly adding heat and then disassembling it.
If heat is applied to the liquid crystal frame, there is a risk of failure, so when applying heat, make sure that the wind hits only the liquid crystal frame.
[ASUS ZENBOOK UX31E LCD Repair and Decomposition Method STEP 6]
I was able to remove the liquid crystal frame.
[ASUS ZENBOOK UX31E LCD Repair and Decomposition Method STEP 7]
Next, I will remove the LCD panel, but i have a screw in the red frame, so remove it.
The screws are on the left and right sides, so be sure to remove both screws.
[ASUS ZENBOOK UX31E LCD Repair and Decomposition Method STEP 8]
When the screw can be removed, the LCD panel can be knocked down to the keyboard side.
There is a transparent sheet on the back of the LCD panel, but only the LCD panel (glass) should be knocked down.
When knocking down the LCD panel, the LCD cable and the backlight ribbon cable are connected, but be careful not to cut them.
The orange ribbon cable is intended to make the backlight glow, but if you fold it or cut it, it will not glow when you change the LCD later, so please work carefully.
You can unplug the ribbon cable by raising the connection part of the liquid crystal base up.
[ASUS ZENBOOK UX31E LCD Repair and Decomposition Method STEP 9]
Then remove the LCD cable from the base.
You can remove the transparent tape by raising it up and sliding it.
If the decomposition up to this point was able to be done accurately, I think that the liquid crystal panel was removed from the personal computer body.
If you replace the newly prepared LCD panel, the liquid crystal repair of the UX31E will be completed.
[ASUS ZENBOOK UX31E LCD Repair and Decomposition Method STEP 10]
At first, it was not visible at all due to a crack in the liquid crystal, but it came to be displayed normally by replacing the liquid crystal panel.
If the screen of ASUS UX31E has a cracked LCD and there is a bad display on the LCD, a liquid crystal panel replacement (LCD replacement) is required!
I want to repair the liquid crystal crack of ASUS UX31E.
There is a connector connecting the motherboard and the battery in the red frame, so remove it.
コメントを残す