How to repair and disassemble if the iPhone6sPlus battery does not have it and cannot be charged
iPhone6plus battery replacement and disassembly procedure
[iPhone6plus Battery Replacement STEP 1]
If the battery drainises faster, if it is inflated, please check this decomposition method will be helpful.
[iPhone6plus Battery Replacement STEP 2]
Remove the screw next to the dock connector, but use a dedicated screwdriver.
If you use a Phillips screwdriver by mistake, you may collapse the screw thread, so be careful.
[iPhone6plus Battery Replacement STEP 3]
Insert the image tool into the gap between the LCD and the main unit.
Then, it is fixed so as not to close using the pick etc. because a little gap can be made between the liquid crystal and the main body.
[iPhone6plus Battery Replacement STEP 4]
When the home button around floats, the side side also floats, so slowly wake up the liquid crystal.
[iPhone6plus Battery Replacement STEP 5]
It is a state that was able to float completely, but please note that the cable related to the liquid crystal is connected to the logic board.
The battery can be removed without removing the liquid crystal, but it is safe to remove it if it is difficult to work because it cannot be fixed. Click here to remove the lcd of the iPhone6Plus.
(up to STEP 7)
[iPhone6plus Battery Replacement STEP 6]
Since the connector of the battery is connected to the logic board, I remove it, but remove two screws of the red frame part.
[iPhone6plus Battery Replacement STEP 7]
When the iron plate comes off, there is a connector below, so it is lifted from the bottom to the top and removed.
[iPhone6plus Battery Replacement STEP 8]
I was able to remove the connector.
[iPhone6plus Battery Replacement STEP 9]
The red frame part is originally attached to the tape to be used when removing the battery, but this model is not in a state because it has been removed several times.
In that case, the tool is used as shown in the image, but the tool used at this time should always be a plastic product. You can see how the tape was used to replace the battery of the iPhoneSE.
[iPhone6plus Battery Replacement STEP 10]
I was able to remove the battery.
Please be sure to use psE mark acquired products for the battery to be replaced!
If the battery drainises faster, if it is inflated, please check this decomposition method will be helpful.
コメントを残す